ZyXEL Communications NSA221 User Manual page 379

For statically assigned settings, do the following:
4
• From the Configure box, select Manually.
• Type your IP address in the IP Address box.
• Type your subnet mask in the Subnet mask box.
• Type the IP address of your gateway in the Router address box.
Click Apply Now and close the window.
5
Restart your computer (if prompted).
6
Verifying Settings
Check your TCP/IP properties in the Network window.
Linux
This section shows you how to configure your computer's TCP/IP settings in Red
Hat Linux 9.0. Procedure, screens and file location may vary depending on your
Linux distribution and release version.
Note: Make sure you are logged in as the root administrator.
Using the K Desktop Environment (KDE)
Follow the steps below to configure your computer IP address using the KDE.
Click the Red Hat button (located on the bottom left corner), select System
1
Setting and click Network.
Figure 208 Red Hat 9.0: KDE: Network Configuration: Devices
NSA221 User's Guide
Appendix A Setting up Your Computer's IP Address
379