Table of Contents
Advertisement
Chapter 20 Authentication & Accounting
Table 47 Advanced Application > Auth and Acct > RADIUS Server Setup (continued)
LABEL
Delete
Apply
Cancel
Accounting
Server
Timeout
Index
IP Address
UDP Port
Shared Secret
Delete
Apply
Cancel
20.2.2 TACACS+ Server Setup
Use this screen to configure your TACACS+ server settings. See
for more information on TACACS+ servers. Click on the TACACS+ Server Setup link in the
Authentication and Accounting screen to view the screen as shown.
148
DESCRIPTION
Check this box if you want to remove an existing RADIUS server entry from the
Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section to configure your RADIUS accounting server settings.
Specify the amount of time in seconds that the Switch waits for an accounting
request response from the RADIUS accounting server.
This is a read-only number representing a RADIUS accounting server entry.
Enter the IP address of an external RADIUS accounting server in dotted decimal
notation.
The default port of a RADIUS accounting server for accounting is 1813. You need
not change this value unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared
between the external RADIUS accounting server and the Switch. This key is not
sent over the network. This key must be the same on the external RADIUS
accounting server and the Switch.
Check this box if you want to remove an existing RADIUS accounting server entry
from the Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
Section 20.1.2 on page 146
ES-2024 Series User's Guide
Advertisement
Table of Contents
