Sr 300 Receiver - AKG HT 300 User Instructions

13.2. SR 300 Receiver

Carrier frequencies:
Channel bandwidth:
3rd order intercept (two-tone test):
Adjacent channel selection:
Image rejection:
Receiver type:
Antenna inputs:
Rated deviation:
Squelch threshold:
Compander characteristic:
Audio bandwidth:
THD at 1 kHz:
-70 dBm RF level:
-85 dBm RF level:
Dynamic range:
Audio outputs:
Current consumption:
Power requirement:
Dimensions (WxHxD):
Net weight:
EU Conformity
This product conforms to ETS 300 445 and ETS 300 422
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC regulations.
Changes or modifications not expressly approved in writing by AKG Acoustics may void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
16 carriers within 20-MHz channel
in 798 to 955 MHz UHF range
up to 20 MHz
0 dBm typ.
60 dB typ.
60 dB typ.
true diversity
2 x 50- BNC sockets
±50 KHz at 1 KHz sine-wave modulation
adjustable between -95 dBm and -80 dBm
rms
70 Hz to 20 KHz
<0.8% at rated deviation
S/N ratio at ±50 KHz deviation,
>100 dB(A) S/N ratio at ±50 KHz deviation,
>90 dB(A)
110 dB typ.
balanced XLR: adjustable from -30 to +6 dBm
unbalanced 1/4" jack: adjustable from -36 to 0 dBm
150 mA typ.
11 to 15 V AC or DC from remote power supply
210 x 45 x 180 mm (8.3 x 1.8 x 7 in.)
approx. 650 g (23 ozs.)
WMS 300
17