Eizo FLEXSCAN L997 Manual page 17

D-Sub
(Ex.1) Analog mini 15
pin
D-Sub
(Ex.2) Analog mini 15
pin
(Ex.2) Digital DVI
Selecting the Active Input
The Input Signal Selection Button on the control panel can be used to select either SIGNAL 1 or SIGNAL
2 as the active input at any time. Every time the button is pressed, the input changes. When switching the
signal, the kind of the input signal (Signal1 or 2/Analog or Digital) is displayed for a few seconds on the
right top corner of the screen.
When pressing the input signal selection button for 2 seconds, the ActiveShot function will be
available. (The sub window will appear. Refer to
When using the
image of the Main window and the Sub window.
The Priority Input Signal
This function is used to select which PC will have priority to control the monitor when utilizing two PCs.
The monitor constantly checks the input signals and switches automatically in accordance with the "Input
Priority" setting (see table below). Once a priority is set, whenever a change of signal is detected at the
selected input, the monitor will switch the input to that signal.
In the case of only one signal being present at either input, the monitor automatically detects and displays
that signal.
PC 1
Signal Cable
(FD-C16 enclosed)
Signal Cable
(FD-C16 enclosed)
Signal Cable
(FD-C39 enclosed)
ActiveShot function, slightly pressing the Input signal selection button switches the
PC 2
Signal Cable
(FD-C39 enclosed)
Signal Cable
(FD-C16 optional)
Signal Cable
(FD-C39 optional)
5. ActiveShot Function)
DVI Analog
D-Sub
mini Analog
15 pin
DVI Digital