Table of Contents
Advertisement
9. TROUBLESHOOTING
If a problem persists even after applying the suggested remedies, contact an EIZO dealer.
No picture problems
Imaging problems
Other problems
USB problems
1. No picture
Indicator status: Off
Indicator status: Blue
Indicator status: Yellow
Indicator status: Slowly flashing Yellow
2. Error messages shown below will remain on the
screen for 40 seconds.
Whenever an error signal message appears, the signal
frequency will be displayed in red.
(Example)
See No.1 ~ No.2
See No.3 ~ No.13
See No.14 ~ No.20
See No.21 ~ 22
Problems
Points to check with Possible Solutions
Check that the power cord is correctly
connected. If the problem persists, turn
off the monitor power for a few
minutes, then turn it back on and try
again.
Check the "Gain" setting.
Switch the signal input by pressing the
Input Signal Selection Button on the
front control panel.
Try pressing a key on the keyboard, or
clicking the
mouse.
Try pressing the power button.
These messages appear when the signal is
not inputted correctly, even if the monitor
functions properly.
When the image is displayed correctly
after a short time, there is no problem
with the monitor. (Some PCs do not
output the signal soon after powering
on.)
Check that the PC is turned ON.
Check that the signal cable is properly
connected to the PC or graphics board.
Switch the signal input by pressing the
Input signal selection button on the front
control panel.
Use the graphics board's utility software
to change the frequency setting. (Refer
to the manual of the graphics board.)
Advertisement
Table of Contents
