Sanyo VCC-HD5400 User Manual page 97

You cannot configure the motion sensor function if the electronic sensitivity boosting (SENSE UP) or
the long exposure shutter mode (LONG) is enabled.
When the automatic pursuit function is set on the PAN/TILT screen, you cannot configure the motion
sensor.
If you configure the automatic pursuit function after enabling the motion sensor, the motion sensor
will be forcibly disabled.
Use the motion detection function to detect motion in specific areas of the subject.
1
On the ALARM SETTINGS screen, in [MOTION], select "DETECT".
2
In [DURATION], select how long you want the alarm state to be retained when the motion
sensor detects motion and click
The MOTION DETECTION screen appears.
5SEC, 10SEC, 15SEC, 20SEC, 30SEC, 45SEC, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN
CC (Retains the alarm state as long as the motion alarm persists.)
The terminal will not accept subsequent alarm signals until the set duration expires.
The alarm state will be retained for at least 5 seconds even if the motion is instantaneous.
The configured duration value will be reset to the factory default value if you change any setting on
the ALARM SETTINGS screen while an alarm state is retained.
To switch the alarm detection method, in [MOTION ALARM], click the desired radio button.
.
DETAIL
Working with Administrator Configuration Screens 51/79