Sanyo VCC-HD5400 User Manual page 64

1
Set [AUDIO] to "ON" in order to enable audio communication.
2
In [MIC SENSITIVITY], specify the microphone sensitivity.
Select the sensitivity of the microphone connected to the camera from 8 levels.
+4, +3, +2, +1, 0, –1, –2, –3
3
In [FILTER(500Hz)], enable or disable the audio filter.
The audio filter reduces the 500 Hz or less frequency components of the audio.
A filter option with a lower negative dB value produces larger effects.
ON(-3dB), ON(-6dB), OFF
4
Configure the audio output level in [OUTPUT LEVEL].
Here, you specify the gain value of the audio output amplifier from the following 4 levels.
+2, +1, 0, –1
5
To mute audio output during PTZ operation, set [MUTE (PAN/TILT, ZOOM)] to "ON" and
click .
SET
Configure the video output terminal to use.
You cannot output video signal from the HDMI connector and the MONITOR OUT connector at the
same time.
1
In [TERMINAL], select the video connector you want to use.
AUTO: A connected connector is detected automatically.
HDMI, MONITOR OUT
If both the HDMI and the MONITOR OUT connectors are connected in "AUTO" mode, the HDMI
connector takes precedence.
Working with Administrator Configuration Screens 18/79