Sanyo VCC-HD5400 User Manual page 116

If no directory name is specified, the system will automatically generate the following directory name.
When sending an alarm image in the event of an error: ALARM_FTP
When sending an image in fixed intervals: INTERVAL_FTP
6
In [FILE NAME], specify the name of the image file you want to send and click
You can type up to 32 alphanumeric characters.
Each image file will have a file name consisting of the specified file name, the date/time, and the
alarm factor (if [TRIGGER] is set to other than "INTERVAL"):
[FILE NAME] + [yy_mm_dd_hh_mm_ss] + [alarm_factor] + [0001 (Serial No.).jpg]
If no file name is specified, the system will enter "sanyo" for the [FILE NAME].
* To use a temporary file, set [TEMPORARY FILE] to "USE".
This causes each image to be stored as a temporary file on the FTP server and then renamed to the specified file
name.
The FTP server will store a single temporary file for the most recent image with the specified file name.
Temporary file name: sanyo_ftp_temp_[IP address].temp
Although the temporary file will be renamed to the specified file name and then stored in the specified
directory as explained in steps
alarm factor information.
Both the temporary and permanent files will be overwritten if the same file name exists.
1
In [TRIGGER], select the image transmission trigger condition.
The setting items you are required to configure are displayed in accordance with the selected trigger condition.
INTERVAL: Sends a still image in fixed intervals.
ALARM IN1-4: Sends an image when a specified ALARM IN terminal receives an alarm signal.
MOTION: Sends a still image when the motion sensor detects motion in the subject.
ALARM OUT1/2: Sends an e-mail when a specified ALARM OUT terminal outputs an alarm signal.
NETWORK FAILURE: Sends a still image when the camera detects a network failure during network
recording.
You need to configure the alarm input/output conditions on the ALARM SETTINGS screen.
If you selected "NETWORK FAILURE" ...
A
In [NETWORK FAILURE TIME], select the time from the occurrence of a network failure until the camera
recognizes it as a recording trigger.
15SEC, 20SEC, 30SEC, 40SEC, 50SEC, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN
The setting values are interlocked among RECORDING, E-MAIL SETTINGS, and FTP SETTINGS
screens. (Note that the setting configured most recently will take precedence.)
5 to 6 , the renamed file name will not include the date/time and
Working with Administrator Configuration Screens 70/79
.
SET