Runco RS-1100 CineWide User Manual page 84

Operation
Gamut
Settings Manual
White x:312 y:329 Y:045
Red x:640 y:330 Y:015
Green x:300 y:600 Y:022
Blue x:150 y:060 Y:018
D. White x:312 y:329 Y:045
Enter
Save
Color Temp.
White x:000 y:000 Y: 000
Changing either or both of these numbers changes the hue of the color and relocates
the "triangle" for possible colors. For example, changing the x/y coordinates for red
moves the color closer to either orange or violet, which in turn affects all displayed
colors having a red component.
Note
To adjust the gamut:
1. Select Gamut from the Advanced Options menu and press ENTER.
2. To do an automatic gamut adjustment, highlight "Enter" and press ENTER. If further
calibration is necessary, continue with the next step.
3. Highlight "Settings" and press
4. Highlight "White" and press ENTER. The RS-900/RS1100 displays a white field on
the screen.
5. Using the color analyzer, measure the x and y coordinates for about 15 seconds.
Make a note of the results.
6500
6. Press EXIT or ENTER.
7. Highlight "White" and press
8. Press ENTER to select the first digit of the x coordinate value for White (obtained in
Step 5).
9. Press or
10. Press to select the next digit; use the
11. Repeat Step 10 for the third digit.
12. Press ENTER.
13. Press to highlight the "y" coordinate value for White. Then, press ENTER to select
the first digit.
14. Repeat Steps 9 through 12 to set the "y" coordinate value for White.
15. Press to highlight the "Y" coordinate value. Then press ENTER to select the first
digit.
16. Repeat Steps 9 through 12 to set the "Y" coordinate value for White.
17. Press EXIT.
18. Repeat Steps 4 through 17 for Red, Green, Blue and D. White (Desired White).
19. Highlight "Save" and press ENTER.
To undo the effects of a previous calibration, highlight "Settings" and press
select "Default."
Reset to Defaults: To restore the ISF default image settings for the current input source
ONLY, select Reset to Defaults and press the
ENTER.
To perform these adjustments, you will need a color analyzer (Sencore
ColorPro 5000 software and ColorPro III sensor, or equivalent).
or to select "Manual."
.
repeatedly to set the digit.
68 RS-900 and RS1100 Series Installation/Operation Manual
and buttons to change it.
button to highlight "Yes." Then, press
or to