Runco RS-1100 CineWide User Manual page 71

Color: On your external test pattern source, select a color bar pattern like the one shown
in Figure 4-4.
Figure 4-4. Typical Color Bar Pattern for Adjusting Color Saturation and Tint
Select Color from the Picture Adjust menu and press ENTER. While looking at the color
bar pattern through a blue filter, adjust the color saturation level until the outermost (gray
and blue) color bars appear to be a single shade of blue:
Tint: Tint or "hue" is essentially the ratio of red to green in the color portion of the image.
When tint is decreased, the image appears redder; when it is increased the image
appears greener. To set the tint, select Tint from the Picture Adjust menu and press
ENTER. While looking at the color bar pattern through a blue filter, adjust the tint level until
the cyan and magenta color bars (on either side of the green bar) appear to be a single
shade of blue.
Like the Brightness and Contrast controls, the color and tint controls
Note
are interactive. A change to one may require a subtle change to the
other in order to achieve the optimum setting.
RS-900 and RS1100 Series Installation/Operation Manual 55
Operation