Runco RS-1100 CineWide User Manual page 22

Controls and Functions
4. TEMP LED
Indicates fan status and internal temperature as follows:
• Off during normal operation
• Red when internal temperature is too high or a fan failure occurs
5. INTAKE VENT
6. POWER/STANDBY LED
Indicates power status as follows:
• Orange when the projector is in standby mode
• Flashes green for approximately 45 seconds after the projector is turned on to
indicate that the lamp is warming up
• Green during normal operation
• Flashes orange for approximately 110 seconds after the projector is turned off to
indicate that the lamp is cooling down
• Red when an internal failure requiring service has occurred
7. LAMP LED
Indicates lamp status as follows:
• Off during normal operation
• Red when the lamp has exceeded its usage life or developed a problem
8. RUNCO LOGO
The logo can be rotated to match the projector orientation: inverted (ceiling-mounted)
or upright. To rotate the logo, grip it at the sides, pull it away from the projector and
rotate it 180 degrees.
9. FRONT IR SENSOR
10. FOCUS RING (Standard RS-900/RS1100)
To adjust the focus, grasp the lens by the outer ring and rotate it. (Use the remote
control unit to adjust the focus with an RS1100 Ultra.)
6 RS-900 and RS1100 Series Installation/Operation Manual