Status Led - Raymarine L1250DRC Owner's Handbook Manual

Chapter 9: Maintenance and Problem Solving

Status LED

The LED on the connector panel provides valuable information on the status
of your DSM250. The LED blinks green while the module is operating
normally. If the unit detects a problem, the LED blinks amber to indicate a
warning or red for an error. The number of times the LED blinks is a code
representing the nature of the problem. For multiple warnings/errors, the
codes are given in sequence with a 1.5 second pause between strings.
The following table shows the various LED status codes and their meanings.
Table 9-4:
W
A
R
N
I
N
G
S
E
R
R
O
R
S
1
After 30 seconds of no
emitted and no warnings are output on the LED.
Instead, the LED blinks green once every 10 seconds.
For example, if the Transducer Sense fails and
blinks amber once, pauses 1.5 secs, blinks amber twice 0.5 secs apart, pause
1.5 secs, and then repeats the sequence until the problems are resolved or (for
some warnings/errors) up to 10 minutes elapse.
Status LED Indications
Color No of Meaning
blinks
Amber 1 Transducer Sense Failure
2
not detected
2
hsb
3 High Temperature Warning
4 Reserved
5 Reserved
6 Reserved
7 Reserved
8 Watchdog Timeout Reboot
Red 1 Unknown Error
2 Battery Voltage Error
3 High Temperature Error
4 Flash Memory Failure
5 Reserved
6 Reserved
7 Reserved
8 Hardware Monitor Failure
activity, the DSM250 enters Standby mode: No sonar pings are
2
hsb
Cleared
every 10 min
1
✔
✔
✔
✔
✔
is not detected, the unit
hsb
2
9-7