The Hsb; The Fishfinder Display - Raymarine L1250DRC Owner's Handbook Manual

1-8

The hsb

System
2
The hsb
compatible units. For example, fishfinder data is transferred from the master
display via the
other hsb
you change a setting (for example: DEPTH RANGE) on one display, it affects all
displays showing fishfinder or fishfinder/chart overlay.
In particular, you connect the DSM250 Digital Sounder Module to the L770D/
RC Plus or L1260D/RC Plus Fishfinder over the
connect your Fishfinder to a remote
to a remote
functionality on all three displays.
Full functionality of the fishfinder is achieved when it is part of an integrated
system, with other equipment (in addition to other
via SeaTalk or NMEA 0183. Data from this equipment including position and
heading is displayed on the display and is used in calculations.
It is possible to connect up to ten
provide an integrated system. Earlier HSB (non-Plus) Display units can be
upgraded to provide
on page 2-26 for details.
Note: Please contact Raymarine Customer Service or your authorized Ray-
marine dealer about upgrading your existing HSB (non-Plus) display units to
provide full
The
hsb
cartridge slots. Each display can access two local and up to six remote chart
cartridges. Charts can be controlled independently on each display, even when
a remote chart cartridge is being used. Details on connecting the equipment
are given in Chapter 2.

1.2 The Fishfinder Display

When you first turn the display unit on and select Sonar mode, the scrolling
bottom graph is displayed. This is a graphical representation of the echoes
seen by the DSM250 and transmitted to the Fishfinder. As time passes, this
display scrolls from right to left and becomes a record of the echoes seen. A
typical display is shown in Figure 1-3.
The images at the right hand side of the display are the most recent echoes.
Some echoes indicate fish and others show the bottom. It can also indicate
bottom structures, such as a reef or shipwreck. The upper and lower depth
range limits are shown.
(High Speed Bus) connection enables transfer of data among
2
connection and can be displayed and controlled on any
hsb 2
Plus Series LCD or CRT display (the repeater display). However, if
2
hsb Series Plus Chartplotter to provide fishfinder, chart, and radar
2
compatibility. See Connecting hsb2 Plus Series Units
2
hsb
Plus functionality.
hsb 2
system can include several chartplotter displays, each with two chart
2
port. In addition, you can
hsb
2
hsb Series Pathfinder Plus Radar and then
2
Plus units) connected
hsb 2
Plus Series LCD or CRT displays to
hsb 2
HD Series Fishfinders