Pioneer Kuro KRP-500M Operating Instructions Manual page 82

Helpful Information
07
Picture/Sound
Issue
Sound is wrong (one side
only or reversed between
left and right)
Brightness and color
tone on the sides differ
from the center
Picture does not appear
properly
After-image lag
KURO LINK
Issue
KURO LINK does not
function
Error message:
device cannot be
operated. Please check
connection"
No picture and sound
No picture
No sound
Panel sounds/noises
82
En
• Check if the speaker cable connections have been reversed between the left and right.
• Confirm that speaker cables are connected and seated properly.
• Check the sound balance and adjust if necessary.
• If images in 4:3 mode or letterbox images are displayed for long periods or for shorter
periods over several days, an after-image may remain due to burning.
Watch images in Full screen as much as possible to avoid this issue.
• Change the Brightness Sync. setting to Auto.
This function adjusts the brightness of the gray side masks for the brightness of the main
image.
• Use the Long Life Settings function (see "4.2.1 Extend Your Panel Life")
• Check the setting for Color Decoding when using INPUT 2 or INPUT 3 (pages 56 and 57).
• Check the setting for Signal Type.
• Check the setting for Video when using INPUT 5 through INPUT 6 (page 58).
• Check the setting for Signal Format when using INPUT 5 through INPUT 6 (page 58).
• If a bright or still image was on screen for a long period before switching to a darker
image, the original image may appear as an after-image or ghost. Try playing another
bright image, switching the picture quickly many times, or show a very active scene.
• Use the Long Life Settings function (see "4.2.1 Extend Your Panel Life")
• Display the Video Pattern screen to help reduce after-image lag.
• Check the connections between the panel and the HDMI equipment.
• Confirm that the settings for the panel are correct.
• Confirm that the equipment is HDMI compliant.
• Confirm that settings for the equipment are correct.
For details, refer to the operating instructions that came with the equipment.
"The • Check the connections between the panel and the HDMI equipment.
• Confirm that settings for the equipment are correct.
For details, refer to the operating instructions that came with the equipment.
• Check the connections between the panel and the HDMI equipment.
• Confirm that settings for the equipment are correct.
For details, refer to the operating instructions that came with the equipment.
• Check the connections between the panel and the HDMI equipment.
• Confirm that settings for the equipment are correct.
For details, refer to the operating instructions that came with the equipment.
• Check the connections between the panel and the HDMI equipment.
• Confirm that settings for the equipment are correct.
For details, refer to the operating instructions that came with the equipment.
• Check that the AV system is connected to an HDMI terminal and any recorder/player is
connected to another HDMI terminal.
• Some sounds are appropriate for plasma technology.
Examples: fan motor noise, electrical circuit humming, glass panel buzzing, etc.
Possible Solutions
Possible Solutions