Panasonic WV-NF284 Network Operating Instructions page 30

Set the VMD areas [VMD area]
Click the [VMD area] tab on the "Alarm setup" page. (☞ page 15)
The video motion detection areas can be set on this page.
When a motion is detected in the set area, the alarm action will be performed.
Set the VMD areas
Step 1
Set the video motion detection area by dragging the
mouse on the screen. When the [All areas] button is
clicked, the whole area will become the VMD area, and
"1 (White)" will be automatically applied to "Area".
→ The designated area will become the VMD area and
the outline will be displayed. When 2 - 4 VMD areas
are set, each area will be numbered in order.
The areas will be identified by the respective outline
colours.
30
Step 2
Select "ON" or "OFF" for "Status" of each VMD area.
When the [SET] button is clicked after selecting "OFF",
the outline will become the broken line and no alarm
action will be performed even when a motion is detected
in the area.
Step 3
Select the detection sensitivity from the following. The
selected detection sensitivity will be applied to all the
VMD areas.
High/Middle/Low
Default setting: Middle
Step 4
Click the [SET] button after completing the settings.
Important:
The setting will not be applied unless the [SET] but-
ton is clicked.