Panasonic WV-NF284 Network Operating Instructions page 28

Configure the settings relating to the alarm image
Click the [Alarm] tab on the "Alarm setup" page. (☞ page 15)
■ Alarm image setup
The settings relating to the alarm image to be transmitted to the FTP server can be configured on this page. The
alarm image will be transmitted to the FTP server. To transmit alarm images to the FTP server, it is necessary to
configure the settings in advance. (☞ page 37)
Refer to pages 27 and 29 for further information about the settings relating to the alarm action at an alarm occur-
rence and the alarm out connector.
Important:
Depending on the network line speed or the network traffic, images may not be transmitted at the exact designat-
ed interval or period.
[To FTP setup]
When "To FTP setup" is clicked, the [FTP] tab of the
"Server setup" page will be displayed. (☞ page 37)
[Alarm image FTP transmission]
Select "ON" or "OFF" to determine whether or not to
transmit the alarm image to the FTP server.
Default setting: OFF
[Directory]
Enter the directory name where the alarm images are to
be saved.
For example, enter "/ALARM" to designate the directory
"ALARM" under the FTP root directory.
Number of characters for the directory name: 0 - 256
characters
28
[File name]
Enter the file name used for the alarm image to be
transmitted to the FTP server. The file name will be as
follows.
["Entered file name" + "Time and date (year/month/day/
hour/minute/second)"] + "Serial number"
Number of characters for the file name: 1 - 8 charac-
ters
[Post alarm]
• Transmission interval
Select a transmission interval for the alarm image
FTP transmission from the following.
0.1 fps/0.2 fps/0.33 fps/0.5 fps/1 fps
Default setting: 1 fps
• Number of images
Select the number of images to be transmitted from
the following.
10 pics/20 pics/ 30 pics/50 pics/100 pics/
200 pics/300 pics/500 pics/1000 pics/2000 pics/
3000 pics/5000 pics
Default setting: 100 pics
• Recording duration
Approximate time to be taken to save the set "num-
ber of images" with the set "transmission interval"
will be displayed.
[Image capture size]
Select "QVGA" or "VGA" for the image capture size of
images to be transmitted to the FTP server or of an
image to be attached to the alarm mail.
Default setting: VGA