Panasonic WV-NF284 Network Operating Instructions page 24

Configure the camera settings such as image quality and brightness, etc. [Camera]
Click the [Camera] tab on the "Camera setup" page. (☞ page 15)
The following are descriptions of how to configure the settings relating to images such as brightness, etc.
[Brightness]
17 steps (–8 - 8) are available for brightness. The value
"–8" is the darkest and "8" is the brightest.
Default setting: 0
[White balance]
Select the white balance adjustment method from the
following.
AUTO: Adjusts the white balance automatically.
HOLD: Fixes to the white balance applied when the
[SET] button is clicked.
Default setting: AUTO
[Aperture level]
9 steps (–4 - 4) are available for aperture level (sharp-
ness). The value "–4" is the softest and "4" is the
sharpest.
Default setting: 0
[Flicker-less mode]
Select "ON" or "OFF" to determine whether or not to use
the flicker-less mode. Normally, select "OFF". When
using the camera under fluorescent lamps and flickers
appear, select "ON".
Default setting: ON
24
Note:
When using the camera under low-light intensity, the
flicker-less function may not work effectively even
when "ON" is selected. In this case, select an inter-
val for "Refresh interval (JPEG)" (☞ page 21) from
the following; 0.1 fps/0.2 fps/0.5 ftp/1 fps/2 fps/5
fps/10 fps
[Sensitivity up]
Select the sensitivity from the following.
OFF: Does not use the sensitivity adjustment.
x2: Adjusts the sensitivity up to x2 automatically.
x4: Adjusts the sensitivity up to x4 automatically.
x8: Adjusts the sensitivity up to x8 automatically.
x16: Adjusts the sensitivity up to x16 automatically.
Default setting: OFF
Important:
When the sensitivity is incremented, the refresh
interval may be longer.
[Backlight compensation (BLC)]
Select "ON" or "OFF" to determine whether or not to
compensate backlight.
ON: Compensates backlight. (Suitable when the subject
has backlight.)
OFF: Does not compensate backlight. (Suitable when
the subject has light in the front.)
Default setting: OFF