Panasonic WV-NF284 Network Operating Instructions page 18

Notes:
• Link indicator: This indicator will light when com-
munication with the connected device is available.
• Access indicator: This indicator will light when
accessing to a network.
• SD memory card error indicator: This indicator will
light when it is impossible to write data on the SD
memory card.
Configure the settings relating to the NTP server [NTP]
Click the [NTP] tab on the "Basic setup" page. (☞ page 15)
The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured on this
page.
[Time adjustment]
Select the time adjustment method from the following.
Manual setup: Time set on the [Basic] tab on the
"Basic setup" page will be used as the standard time
of the camera.
Synchronization with NTP server: Time automatically
adjusted by synchronizing with NTP server will be
used as the standard time of the camera.
Default setting: Manual setup
[NTP server address]
Enter the IP address or the host name of the NTP serv-
er.
Number of characters for the NTP server address:
1 - 128 characters
Default setting: (blank)
18
Important:
When entering the host name for "NTP server
address", it is necessary to configure the DNS set-
tings on the [Network] tab of the "Network setup"
page. (☞ page 39)
[NTP port]
Enter a port number to be used for the NTP server.
Available port number: 1 - 65535
Default setting: 123
[Synchronization interval]
Select an interval (1 - 24 hours: in 1 hour intervals) of
synchronization with the NTP server.
Default setting: 1 hour
[Time zone]
Select a time zone according to the location where the
camera is in use.
Default setting: (GMT) Greenwich Mean Time: Dublin,
Edinburgh, Lisbon, London