Panasonic WV-NF284 Network Operating Instructions page 29

Configure the settings relating to the alarm out connector
Click the [Alarm] tab on the "Alarm setup" page. (☞ page 15)
■ Alarm output terminal setup
The settings relating to the alarm out connector can be configured on this page. Refer to pages 27 and 28 for further
information about the settings relating to the alarm action at an alarm occurrence and the alarm image.
[Alarm output setup]
Select "ON" or "OFF" to determine whether or not to
output the alarm signals to the alarm out connector
when an alarm is detected.
Default setting: OFF
[External terminal output setup]
Select "Latch" or "Pulse" for the alarm out connector at
an alarm occurrence.
Latch: When an alarm is detected, alarm output con-
nector will be in the state selected for "Alarm output"
until the [Alarm reset] button is clicked.
Pulse: When an alarm is detected, alarm output con-
nector will be in the opposite state to the "Alarm out-
put" setting for the period set for "Pulse width".
Default setting: Latch
[Alarm output]
Select "Open" or "Close" to determine whether to open
or close the alarm output connector when output the
alarm signals.
Open: The alarm out connector will open when output
the alarm signals. (Normally close)
Close: The alarm out connector will close when output
the alarm signals. (Normally open)
Default setting: Open
Note:
When "Open" is selected, the alarm signal will be
output for around 20 seconds when the power of the
camera is turned on.
[Pulse width]
When "Pulse" is selected for "Alarm output", select an
pulse width.
Available value: 1 - 120 sec
Default setting: 1 sec
29