Mounting the Viewfinder and Adjusting its
Position
This section shows how to mount and adjust the
supplied viewfinder and the optional AG-VF11G
viewfinder, which is equivalent to the supplied one.
When using a viewfinder other than these two
viewfinders, see the Operating Instructions provided
with that viewfinder.
• Note that old attachment models are not supported.
Mounting the Viewfinder
1
Confirm that the POWER switch is
turned off.
2
Connect the plug to the viewfinder
connector.
<Note>
Make sure that the plug is firmly seated in the
viewfinder connector.
Loosen
3
Loosen the viewfinder right-left
positioning ring.
4
Turn the viewfinder securing screw
counterclockwise (to cancel the safety
mechanism) and slide the viewfinder in
the direction of the arrow.
88
Mounting the Viewfinder and Adjusting its Position
Viewfinder securing screw
5
Turn the viewfinder securing screw
clockwise (to prevent it from falling
off).
6
Tighten the viewfinder right-left
positioning rings.
<Note>
Be sure to firmly tighten the viewfinder securing screw
on the viewfinder right-left positioning module. The
viewfinder may fall off if the viewfinder securing screw
is not properly tightened.
Adjusting Viewfinder Right-
Left Position
1
Loosen the viewfinder right-left
positioning ring.
2
Slide the viewfinder right and left to
find a position that facilitates viewing.
Tighten
Viewfinder right-left positioning ring
3
Tighten the right and left viewfinder
positioning ring.