Table of Contents
Advertisement
Chapter 5 Preparation
5-1-2 Using an AC Power Supply
When using the Panasonic AJ-B75 AC adapter
1
Plug the AJ-B75 DC OUT connector into the camera-
recorder's external DC input socket.
AC Adapter
AJ-B75 (Optional)
2
Turn the AC adapter power ON.
3
Turn the camera-recorder power switch ON.
When using an external power supply other than the
AC adapter AJ-B75, check the DC IN socket pin
information to ensure correct polarity. If a +12V power
supply is accidentally connected to the GND terminal,
this could cause a fire or personal injury.
4
1
2
3
DC IN Socket
<Notes>
When both the battery pack and AC adapter are
connected, power is supplied from the AC adapter.
The battery can be removed or mounted while using
the AC adapter.
When using the AC adapter, make sure you turn ON
the AC adapter power before turning ON the camera-
recorder's power switch. If this sequence is reversed,
the camera-recorder may malfunction due to slow
rising of the AC adapter output voltage.
When connecting a battery to the DC IN socket,
select the battery type listed under EXT DC IN
SELECT. Select EXT DC IN SELECT from the
<BATTERY/P2CARD>
OPERATION page. In this case, however, the %
display is disabled, even when using a digital battery.
(continued)
DC IN Socket
Pin No.
Signal
1
GND
2, 3
—
4
+12V
screen
on
the
MAIN
5-2 Mounting the Viewfinder and
Adjusting its Position
Please refer to the viewfinder instruction manual.
Note: A slide rail is required to mount any viewfinder other
than models AJ-VF15B or AJ-VF20WB.
If you need to buy a slide rail, please contact the store
where you purchased the camera-recorder and tell them
that the slide rail is a "repair part".
Slide rail (VFC3995)
Screws (XBS3+8VZ)
Mounting the Slide Rail
1
Undo the upper two screws for AJ-VF15 or AJ-VF20W,
and remove the mounting unit.
Leave the screws attached to the mounting unit.
Mounting unit
Screws
2
Mount the slide rail, then tighten the two screws.
Slide rail
5
67
Advertisement
Table of Contents
