Chapter 5
Configuration Examples
Installing Remote Annex Network Software for Windows
5-8
2.
Choose the appropriate modem from the Modem Type list.
3.
Click on Both in the Direction Box and AutoDetect in the Mode
box.
4.
Click on Apply.
Quick2Config Annex opens a dialog box so you can confirm that you
want to reset the port
Setting Flow Control and Speed
To set the flow control and maximum speed:
1.
With Port 2 selected, click on the Line Control tab.
Quick2Config Annex displays the tab for setting flow control and
modem speed
2.
Click on Use Modem Signals (DTR/DCD/DSR) for Flow Control.
3.
Click on Hardware (RTS/CTS) in the Flow Control box.
4.
In the Serial Port Speed box, choose 115200 or the maximum
DTE speed supported by the modem.
5.
Click on Apply.
Quick2Config Annex displays the Reset Confirmation dialog box
(Figure
5-5).
6.
Click on OK.
Quick2Config Annex resets the Annex and confirms the modem
settings.
(Figure
5-5).
(Figure
5-8).