Bay Networks 2000 Installation Manual page 101

Appendix A Configuring the NetManage ChameleonNFS IP Stack (16-bit)
2. Click on the down arrow in the Vendor field to display the list of
vendors and choose the hardware vendor for your network
adapter card. Choose "Other" if your hardware vendor is not
supported and follow instructions in the next section,
Unsupported Vendor and Board Type
3. Click on the down arrow in the Board Type field to display the
list of board types and choose the board type you are using.
Refer to the documentation included with your network adapter
card. If you do not see your board type listed, return to the
vendor field and choose "Other." Then go to the next section,
Unsupported Vendor and Board Type
4. Click on the down arrow in the Interrupt Level field to display the
list of interrupt levels and choose the interrupt level (not
required for some cards). Refer to the documentation included
with your network adapter card for interrupt level information.
5. Click on the down arrow in the Transceiver Type field to display
the list of transceiver types. The transceiver type is usually
external. Refer to the documentation included with your network
adapter card for information. Choose the transceiver type (not
required for some cards).
6. Click on the down arrow in the I/O Base Address field to display
the list of I/O base addresses. Refer to the documentation
included with your network adapter card for base I/O address
information. Choose the I/O base address (not required for
some cards).
7. Click on OK.
The Custom program adds entries to the protocol.ini file in
the Windows directory; for example, c:\Windows\protocol.ini .
Installing Remote Annex Network Software for Windows
.
.
A-7