Control Device - Lorex L20WD800 Series Instruction Manual

System Menu
Factory Defaults
The System can be returned to the Factory
default settings:
• Select the 'Factory Defaults' option by
selecting the PRESS button.
• Choose OK to reset the unit, or CANCEL
to exit without resetting.
NOTE: If the System is reset to Factory
Defaults, all settings will be lost (except
the Date and Time).
System Data
The System settings can be saved to a USB
memory stick:
• Insert the Memory stick into the System
and select the Save option to save
settings:
A Success message indicates that the
backup was completed.
44
If the device is not detected, a message
will indicate that No storage device was
found.
• Insert the Memory stick into the System
and select the Load option to restore
settings.
This is recommended after
initial setup and installation is
complete.

CONTROL DEVICE

Used with an external control device (not
included with the system):
• System ID - Select system ID. (1~254).
This is used to set a different ID number
to the System (if used, reset the Remote
Control ID to match the system ID).
• Protocol - Select protocol (from the
Device user Manual).
• Baud rate - Setup baud rate (from the
Device user Manual).