Tuning; Stations - Aiwa AV-D50 Operating Instructions Manual

MANUAL TUNING
DIRECT TUNING
MONO
TU~ER
1 Press the TUNER button repeatedly to select the
desired band.
~FM~AM-1
The display changes to frequency indications after indicating
band and video source (VI, V2 or V3) for two seconds.
When the TUNER button is pressed while the power is off,
the power is turned on directly.
2
Press the UPAA or DOWNY button to select a
station.
Each time the button is pressed, the frequency changes.
Whe~ a station is received, "TUNE" is displayed for two
seconds. During FM stereo reception, [IK3DII) is displayed.
To search for a station quickly (Auto Search)
Keep the UPA
or DOWNV button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops,
To stop the Auto Search manually, press the
UPA
or DOWNV
button.
The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button on the remote control so that
"MONO" appears on the display.
Noise is reduced, although reception is monaural.
MONO
POWER
AA.
When you know the frequency of the desired station, you can
tune in directly to the station.
1
2
3
Press the TUNER button to select a band.
Press the TUNER button and hold it
dlown until
66
. . . . ."flashes on the display (DirectTuning Mode).
Press the appropriate numbered buttons to tune
in to the desired station.
Example:
To tune into 106.50 MHz, press 1, 0, 6, 5 and O buttons.
To tune in to 95.20 MHz, press 9, 5, 2 and !2 buttons.
m
To cancel the Direct tunitng mode
Press the
UPA
or DOWNV button.
m
When entering a frequency out of tuning range, the valuls
flashes for two seconds anc~then goes off. Check the freql~ency
and repeat step 3 correctly.
When entering a frequency not covered by the tuning interval,
the value is automatically rounded up or down to the cllosest
one covered by it.
s The DIGIT buttons on the remote control can not be used wheln
tuning in to the desired station.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 lkHz/step. If
you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Hold down the TUNER button and press the POWER button
immediately. Note that the unit is set to the Direct Tuning mode
if the TUNER button is pressed and held down for a!2w!_&M
a second.
To reset the interval, repeat this procedure.
To restc)re stereo reception, press the button so that "MONO"
disappears.
ENGLISH 12