Ram Disk - Kyocera FS-7000+ User Manual

RAM DISK

RAM DISK

Setting the RAM DISK Size
2-32
The RAM DISK function can be used when the total printer memory is 12 MB or more. A RAM DISK
can be set up as a virtual media device by setting a given amount of the total printer memory as the
RAM DISK. This can then be used for reading and writing data just as with a memory card or as a
virtual mail box function (see page 2-34). Note however that data written to the RAM DISK is lost if the
printer is reset or its power turned off. RAM DISK settings can be made from the printer's control
panel.
Notes ____________________________________________________________________
The RAM DISK is set from the printer's user memory. The printer's printing speed may therefore
drop or insufficient memory errors result depending on the value of the RAM DISK setting.
RAM DISK functions cannot be used if an optional hard disk unit is installed.
Press the MODE key.
1.
Press the + or – key and select RAM DISK mode >. (This menu appears when total printer
2.
memory is 12 MB or more.)
The default setting is Off. Pressing the ENTER key will cause a ? to flash. Press the + or – keys
3.
to display On and then press the ENTER key.
Press the 4 key to display >RAM DISK size.
4.