Important Safeguards - Kyocera FS-7000+ User Manual

Ozone concentration

IMPORTANT SAFEGUARDS

CDRH regulations
The Center of Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration
implemented regulations for laser products on August 2, 1976. These regulations apply to laser
products manufactured after August 1, 1976. Compliance is mandatory for products marketed in the
United States. A label indicating compliance with the CDRH regulations must be attached to laser
products marketed in the United States.
The printer generates ozone gas (O
unpleasant smell. To minimize concentration of ozone gas to less than 0.1 ppm, we recommend you
not to install the printer in a confined area where ventilation is blocked.
Read all of these instructions and save these instructions for later use.
1.
Unplug this product from the wall outlet before cleaning.
2.
Do not use this product near water.
3.
Do not place this product on an unstable cart, stand, or table. The product may fall, causing
4.
serious damage to the product.
Slots and openings in the cabinet and the back are provided for ventilation to ensure reliable
5.
operation of the product and to protect it from overheating, these openings must not be blocked
or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or
other similar surface. This product should never be placed near or over a radiator or heat
register. This product should not be placed in a built-in installation unless proper ventilation is
provided.
) which may concentrate in the place of installation and cause an
3
Introduction
ix