Power Supply - Kyocera FS-7000+ User Manual

Environmental Requirements of the Page Printer

Power Supply

1- 4
The printer should not be on the same power circuit as an air conditioner, fluorescent light, copier, or
shredder, because these devices generate electrical noise on the power line. If it must share a power
circuit with equipment like this, a high-frequency noise filter or isolation transformer is advisable.
(Filters and transformers are available commercially.)
Avoid using plug multipliers to connect a large number of devices on the same circuit as the printer.
If the power from the outlet itself appears to be unstable, a line stabilizer should be used. In places
where the voltage tends to fluctuate, it may be necessary to install a voltage regulator.
As the disconnect device is not incorporated in the printer's AC primary circuit, an easily
accessible socket outlet must be provided near the equipment.
If the printer is used with the optional bulk paper stacker (ST-30), mail box/sorter (SO-30), or
document finisher (DF-30/DF-31), in order to avoid short-circuiting, it should be ensured that
these devices are plugged securely into their respective power outlets.
Da kein Trennschalter in den Wechselstrom-Primärkreis des Druckers eingebaut ist, muß
eine leicht zugängliche Steckdose in der Nähe des Gerätes vorhanden sein.
Wenn der Drucker mit dem gesonderten Stapler (ST-30), Pastfach/Sortierer (SO-30), oder
Finisher (DF-30/DF-31) verwendet wird, muß darauf geachtet werden, daß diese Geräte
einwandfrei an separate Steckdosen angeschlossen sind, um Kurzschluß zu vermeiden.