Recording From A Cd - Aiwa CX-N4000 U Operating Instructions Manual

2
DOLBYNR
~NR
3
REVMODE
k+3+c4
5
\
6
REC/REC MUTE
m
RECORDING FROM A CD
Preparation
W;nd up to the point where recording will start.
Use a normal (type I) tape for recording.
1
2
3
4
5
6
Insert the tape to be recorded on into the deck.
Press the ~ EJECT mark to open the cassette holder.
Insert the tape with the side to be recorded on first facing you
and the exposed side down.
Set DOLBY NR.
To record with DOLBY NR: Press the DOLBY NR button to turn
on the 00 NR indicator.
To record without DOLBY NR: Press the DOLBY NR button to
turn the indicator off.
Set the reverse mode.
Each time the REV MODE button is pressed, the reverse mode
changes.
To record on one side only, turn on =.
To record on both sides, turn on 0 or C=).
Press the CD button.
Load discs onto the disc trays.
The disc loaded on tray 1 is played first.
Press the REC/REC MUTE button to start record-
ing.
Playing and recording stari simultaneously with the first track of
the first disc. All discs in the compartment are recorded if the
tape is long enough.
When you use the remote control to start recording, first press
the ./0 REC/REC MUTE button and then press the 4-
button within 2 seconds.
To stop recording from the CD
Press the W button to stop the deck, and press it again to stop the
CD player.
After
play stops at the end of the CD
The cassette deck enters recording stop mode.
To
record selected tracks
Before pressing the REC/REC MUTE button, program the
tracks. (See page 36.)
To record part of the CD
When the REC/REC MUTE buttonis pressed, recordingalways
startsfrom the firsttrack. To start in the middleof a track, play the
CD up to the pointwhere you want to start recording and press the
II button to pause it. Then press the REC/REC MUTE button.
52