Recording A Whole Cd - Aiwa XR-MR5 Operating Instructions Manual

RECORDING A WHOLE CD

PUSH EJECTz
s
AUTO.F(RW)
MANUAL.F
CD-R/RW
zCD-R/RW
OPEN/CLOSE
DISPLAY
1 Load a CD-R or CD-RW in the CD-R/CD-RW player/
recorder.
Load the disc with the label side up. To open or close the disc
tray, press z CD-R/RW OPEN/CLOSE.
zCD-R/RW OPEN/CLOSE
2 Press CD and load a CD to be recorded in the CD
player.
Press the PUSH EJECT z position to open the disc
compartment and load the disc with the label side up. Then
close the disc compartment.
Wait until the unit finishes reading the loaded discs. (Make
sure the "CD-R" or "CD-RW" indicator lights up, and the total
number of tracks and total playing time of the CD are displayed.)
DISPLAY
CD
s
MANUAL.F
AUTO.F
SHIFT
PUSH EJECTz
3 For manual finalizing recording, press
MANUAL.F on the main unit or on the remote
control.
For auto finalizing recording (only for a CD-RW),
press AUTO.F (RW) on the main unit or AUTO.F on
the remote control.
"AUTO FINALIZE" (Appears only for
auto finalizing recording)
Recording source and destination
Recording stops automatically when the last track on the CD
finishes playing.
When recording finishes, the "CD-R/RW REC" indicator disappears
in the display.
To stop recording before the end of the CD
Press s. Recording stops.
To stop play of the CD, press s again.
To record on a previously recorded CD-R or CD-RW
If there is an unrecorded section left on the CD-R or CD-RW, the
new recording automatically starts from where the previous
recording finished. If you want to start recording from the beginning
of a previously recorded CD-RW, erase the previous recording
completely. (See page 24.)
A finalized* CD-R or a finalized CD-RW, however, cannot be
recorded on.
* See "FINALIZATION" on page 23.
To change the display during recording
Press DISPLAY on the main unit or press DISPLAY while pressing
SHIFT on the remote control. (See page 31 for details.)
NOTE
You can change from auto finalizing recording to manual finalizing
recording by pressing MANUAL. F before recording is completed.
To do the opposite, similarly press AUTO.F (RW).
En
19
ENGLISH