HP Visualize J7000 Supplementary Manual page 71

Table 3-1. Chassis Codes for J5000 and J7000 Workstations
Ostat Code FRU
FLT 7843 SYS BD
FLT 7844 SYS BD
FLT 7845 SYS BD
FLT 7846 SYS BD
FLT 7848 SYS BD
FLT 785s DIMM
FLT 786s DIMM
FLT 787s DIMM
FLT 788s DIMM
FLT 7890 DIMM
FLT 7891 DIMM
FLT 7892 SYS BD
FLT 7893 SYS BD
FLT 7900 SYS BD
FLT 7901 SYS BD
FLT 7902 SYS BD
FLT 7903 SYS BD
FLT 7904 SYS BD
FLT 7905 SYS BD
FLT 79FF SYS BD
WRN 80F3 SYS BD
Chapter 3
Message
fwd prog invalid
mem HPMC summ wd
mem ctlr stat wd
mem err overflow
addr not mapped
MBE in DIMM s
SBE&MBE DIMM s
mem err DIMM s
SBE in DIMM s
MBE overwrt SBE
dup entry in PDT
PDT write error
PDT is full
no DMT entry
no rank entry
bad refrsh intvl
mem intrlv fail
mem reloc failed
mem intrlv error
mem firmware err
err rd IODC byte
Identifying LCD-Indicated Conditions
Description
Memory forward progress word is invalid.
Printing memory error summary word to
RS-232.
Printing memory controller status word to
RS-232.
Multiple memory errors detected.
Memory address outside configured
memory space.
Destructive memory test detected an
uncorrectable memory error in DIMM s.
Destructive memory test detected both an
uncorrectable and a correctable memory
error in DIMM s.
Destructive memory test detected a
pattern compare error in DIMM s.
Destructive memory test detected a
correctable memory error in DIMM s.
Firmware replaced a correctable memory
error entry in the PDT with an
uncorrectable memory error entry at the
same address.
The PDT already contains an entry at
that address.
Error adding the entry to the PDT.
The PDT is full--cannot add new entry.
Internal error--cannot find DIMM entry.
Internal error--cannot find rank entry.
Computed refresh interval is invalid.
Cannot generate memory interleave.
Cannot interleave with relocated range
(3.75GB - 4.0GB).
Undefined memory interleave failure.
Internal error--never expected this to
happen.
Cannot read IODC from ROM or card.
Troubleshooting
67