HP Visualize J7000 Supplementary Manual page 67

Table 3-1. Chassis Codes for J5000 and J7000 Workstations
Ostat Code FRU
WRN 7017 DIMM
FLT 701F DIMM
TST 7020 SYS BD
TST 703s DIMM
FLT 704s DIMM
TST 705s DIMM
INI 706s DIMM
INI 70F0 DIMM
TST 7100 SYS BD
WRN 7101 SYS BD
FLT 7102 SYS BD
FLT 7103 SYS BD
FLT 7104 SYS BD
FLT 7105 SYS BD
FLT 7106 SYS BD
INI 7200 DIMM
INI 7201 DIMM
WRN 7202 SYS BD
FLT 7203 DIMM
FLT 7204 DIMM
INI 7205 DIMM
Chapter 3
Message
skip mem pair ck
no memory found
search for IMM
DIMM s IMM vrfy
DIMM s IMM fail
DIMM s IMM test
DIMM s is IMM
DIMM scan done
mem register tst
skip mem reg tst
mem addr reg tst
mem mbat reg tst
mem reg tst fail
mem err reg test
mem err clr fail
strt DIMM detect
DIMM detect x %
skip DIMM detect
unsupp DIMM type
SPD fatal error
add HP DIMM type
Identifying LCD-Indicated Conditions
Description
Bypass memory DIMM set check.
Memory scan couldn't find any DIMMs.
Try to find a single memory bank to use
for the initial memory module.
DIMM s was the initial memory module
last boot. Verify it still works.
DIMM s failed the initial memory module
test.
Test DIMM in slot s as the initial memory
module.
DIMM s chosen as initial memory module.
Memory DIMM scan complete.
Start testing registers in memory
controller.
Bypass the memory controller register
test.
Firmware detected an error in the
memory controller address registers.
Firmware detected an error in the
memory controller bank registers.
Firmware detected an error in the
memory controller memory registers.
Firmware detected an error in the
memory controller error registers.
Firmware was unable to clear the error
registers after testing.
Start the Serial Presence Detection (SPD)
to search for memory DIMMs.
SPD is x% finished.
Bypass Serial Presence Detection.
SPD found an unsupported DIMM type.
SPD detected an unexpected, fatal error.
New HP manufactured DIMM type added
to tables.
Troubleshooting
63