HP Vectra XW User Manual page 111

SCSI Device
Configuration Menu
4 Troubleshooting Your Personal Workstation and Using the Setup Program
This menu lets you configure parameters for each SCSI device on the
SCSI bus. To configure a specific SCSI device, you need to know which
SCSI ID it uses.
SCSI Device ID
Initiate Sync Negotiation... yes
Maximum Sync Transfer Rate.. 10.0 10.0 10.0 10.0 10.0 10.0 10.0 10.0
Enable Disconnection........ yes
Options Listed Below Have NO EFFECT if the BIOS is Disabled
Send Start Unit Command....
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit
Use the and
display a menu with a selection of values.
• Initiate Sync Negotiation
Some older SCSI-1 devices do not support synchronous negotiation.
Set Initiate Sync Negotiation to
• Maximum Sync Transfer Rate
Certain older SCSI-1 devices do not support Fast SCSI data transfer
rates (typically 10.0, 8.0, and 6.7). Select a Maximum Sync Transfer
Rate of 5.0 for these devices.
• Enable Disconnection
To optimize SCSI bus performance, Enable Disconnection should be
set to when two or more SCSI devices are connected to the host
Yes
adapter. Set Enable Disconnection to
performance when only one SCSI device is connected to the SCSI
bus.
SCSISelect(TM) Utility v1.xxx
SCSI Device Configuration
#0 #1 #2
yes yes
yes yes
no no no
keys to move between options. Press
for these devices.
No
Using the HP Setup Program
#3 #4 #5 #6 #7
yes yes yes yes yes
yes yes yes yes yes
no no no no no
to achieve slightly better
No
to
English 99