HP Vectra XW User Manual page 104

Configuring the SCSI
Interface
Flexible Disk Drives
4 Troubleshooting Your Personal Workstation and Using the Setup Program
Using the HP Setup Program
You can install and use a SCSI host adapter board, and also use the
integrated SCSI interface. However, if you want to use the SCSI host
adapter board only, you can disable the integrated SCSI interface. To
disable the integrated SCSI interface, highlight the
option and select
Interface
Integrated SCSI Interface
Integrated Interface
SCSI BIOS . . . . . . . . . . . . Not Available/Enabled
Ultra SCSI . . . . . . . . . . . Automatic/Enabled/Disabled
Do not change the
Ultra SCSI
familiar with the restrictions of Ultra SCSI. To access advanced SCSI
device configuration options, restart the Personal Workstation and
press when the message
is displayed.
If you install a flexible disk drive that uses the integrated disk interface,
the Setup program should detect and configure the drive automatically.
If you have two flexible disk drives, highlight
select or
Drive 1 Drive 2
will use to start (boot) from a system diskette.
Flexible Disk Drives
Drive 1 . . . . . . . . . . . . . 3.5-inch, 1.44 MB
Drive 2 . . . . . . . . . . . . . None
Bootable Drive
Interface . . . . . . . . . . . . Integrated/Controller Board
If you install a flexible disk drive that has its own controller board,
highlight the
Interface
Configure the controller as described in its manual.
92 English
.
Disabled
Setup xxx.xx.xxx.xx
. . . . . . Enabled/Disabled
option from
Press <F6> for SCSISelect Utility
. This is the drive your Personal Workstation
Setup xxx.xx.xxx.xx
. . . . . . . . . Drive 1
option and select
Integrated
F1=Help On/Off
unless you are
Automatic
Bootable Drive
F1=Help On/Off
Controller Board
and
.