Single Button Connect Dialog Box - HP Compaq t1000 Series Supplementary Manual

252
Client Security
Figure 42-3 Single Button Connect Dialog Box
To enable this function:
1. Press F2 to invoke the Terminal Properties dialog box.
2. Click on the Security tab to invoke the Security properties sheet.
3. Highlight the user's name in User Accounts.
4. Click on the AutoLogin Enable check box to enable the function.
5. Click on the Single Button Connect check box to enable the function.
6. Click on OK.
7. Click on the Shut Down... command button in the Connection Manager.
8. Click on the Logout radio button to log out of the terminal.
The Single Button Connect dialog box appears. Click on Connect to log into the
terminal again.