Terminal Settings Change Dialog Box; System Settings Change Dialog Box - HP Compaq t1000 Series Supplementary Manual

Advanced User Interface
2. Click on the Reset the Terminal to Factory Default Property Settings check
box. Figure 4-2 shows the System Settings Change dialog box that displays.
3. Click on Yes to start the reset process. The terminal will restart with the factory
defaults in effect. The Setup Wizard displays when the terminal resets.
Note
If the above reset procedure fails, call technical support
at Compaq (800-OKCOMPAQ) for instructions on using
a hot-key reset procedure.
Figure 4-2 System Settings Change Dialog Box

Terminal Settings Change Dialog Box

When you change terminal properties using the Setup Wizard or the Terminal
Properties dialog box, you will click on either the Finish or OK command button to
save your new settings and close the application. The Terminal Settings Change
dialog box will then display. Figure 4-3 shows the Terminal Settings Change
dialog box.
41