Table of Contents
Advertisement
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
Schedule
For optimum performance from your machine, fol-
low this maintenance schedule:
Daily
•
Check/correct loose hardware.
•
Check/correct damaged knives.
•
Check/correct worn or damaged wires.
•
Correct any other unsafe condition.
Every Ten Hours of Service
Lubricate chains and gears, (Page 24).
•
Monthly
•
Check for belt tension, damage, or wear.
•
Remove cutterhead guard and thoroughly
clean all built-up sawdust from the cutterhead
area.
Cleaning
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. If
resin has built up, use a resin dissolving cleaner
to remove it.
-20-
Extension Wings
Your planer is equipped with front and rear
extension wings. Each wing folds up for machine
mobility and folds down for machine operation.
To check the alignment, lay a straightedge across
the bed and both wings (see Figure 18).
Adjustment Bolt and Lock Nut
Figure 18. Aligning extension wings.
If adjustment is necessary, proceed as fol-
lows:
1.
Loosen the lock nuts and adjustment bolts
underneath each extension wing.
2.
Hold a straightedge across the bed and both
wings, and turn the adjustment bolts so the
wings and the table are on the same plane.
3.
Without turning the adjustment bolts, tighten
the lock nuts. Recheck to ensure consistency
from side-to-side.
G0663 12½" Planer
Advertisement
Table of Contents
