Dv Record Audio; Auto Chapter; Disc Settings; Disc Initialize - GoVideo VR3845 User Manual

Initial Setup (Continued)

DV Record Audio

You only need to set DV Record Audio if you have a
digital camcorder with 32kHz/12-bit sound connected to
the front panel DV IN jack. Some digital camcorders
have two stereo tracks for audio. One is recorded at the
time of shooting; the other is for overdubbing after
shooting.
• With the Audio 1 setting, the sound that was record-
ed while shooting is used.
• With the Audio 2 setting, the overdubbed sound is
used.
Disc Record Mode
VCR Record Mode
DV Record Audio

Auto Chapter

Prev.
Auto Chapter
During recording, chapter markers are added automati-
cally at fixed intervals. You can set this interval to 5 min-
utes or 10 minutes. To turn off automatic chapter mark-
ing, select "OFF".
Disc Record Mode
VCR Record Mode
DV Record Audio
Auto Chapter
Prev.

DISC Settings

Disc Initialize

When you load a blank disc, the recorder will initialize
the disc.
DVD-R: The recorder initializes the disc in Video mode. The
Record mode will always be Video mode.
DVD-RW: You will be prompted to initialize the disc in
Video mode (for maximum compatibility) or VR
mode (for maximum editing ability).
DVD+R: The Initialize menu appears. Select "Yes" then
press ENTER.
DVD+RW: The recorder initializes the disc in DVD+RW
mode.
Also, you can format the disc from the Setup menu as
shown below.
24
Audio 1
Audio 2
Select Close
OFF
5 Min
10 Min
Select Close
Disc Initialize
Disc Finalize
Disc Label
Disc Protect
PBC
AutoPlay
YourDVD
1 1
Prev.
2 2
Press SETUP.
The Setup menu appears.
3 3
Use v / V to select the DISC option.
4 4
While the DISC option is selected, press B to
move to the second level.
5 5
Use v / V to select the Disc Initialize option.
6 6
Press B to move to the third level.
The Start icon is highlighted.
7 7
Press ENTER.
The Disc Initialize menu appears.
If the disc is a DVD-RW, use b / B to select the
desired Disc Initialize Mode (VR Mode or Video
Mode) then press ENTER.
If the disc is a DVD+RW, go to step 8.
Disc Initialize
Select a mode.
VR Mode
8 8
Use b / B to select "OK", and press ENTER.
It may take a few minutes to initialize the disc.
Disc Initialize
All data on the disc will be deleted.
Proceed?
OK
Caution
If you change the disc format, everything recorded
on the disc will be erased.
Start
Select Close
Video Mode
Cancel