Gigabyte GA-MF3 User Manual page 68

After that, the Array List screen displaying the RAID array you created will appear (Figure 8).
If you want to set the disk array as boot device, use the UP or DOWN ARROW key to select the array
and press B. The Boot section will show Yes.
Boot
BBS
[Ctrl-X] Exit
To read more information about the RAID array, press ENTER to enter the Array Detail screen (Figure
9), where you should see detailed information about RAID mode, disk block size, disk model name,
and disk capacity, etc.
RAID Mode: Striping
Striping Width : 1
Adapt Channel
1 0
1 1
[R] Rebuild
To delete the array, press D in the Array Detail screen. When the "Delete this array?" message appears,
press Y to confirm or N to cancel. Press ENTER to return to the Array List screen.
To exit the Nvidia RAID utility, press ESC in the main menu or Ctrl+X in the Array List screen.
Now, you can proceed to install the SATA controller driver and operating system.
GA-MF3 Motherboard
NVIDIA RAID Utility May 10 2004
- Array List -
Id Status Vendor
2 Healthy NVIDIA
[ ] Select [B] Set Boot
Figure 8
Array 2 : NVIDIA STRIPE 68.95G
- Array Detail -
Striping Block:64K
M/S Index Disk Model Name
Master 0 ST3120026AS
Master 1 ST3120026AS
[D] Delete [C] Clear Disk
Figure 9
- 68 -
Array Model Name
STRIPE 68.95G
[N] New Array [ENTER] Detail
Capacity
34.47GB
34.47GB
[ENTER] Return