Gigabyte GA-MF3 User Manual page 64

(2) Configuring SATA controller mode and boot sequence in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup and set the first boot
device.
Step 1:
Turn on your computer and press Del to enter BIOS Setup during POST (Power-On Self Test). In BIOS
Setup, go to Integrated Periperals --> RAID Config (Figure 1).
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
RAID Config
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
IDE DMA transfer
Serial-ATA 2(Internal PHY)
SATA DMA transfer
USB Memory Type
AC97 Audio
On-Chip LAN(nVIDIA)
OnBoard LAN Boot ROM
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
USB Host Controller
Legacy USB Keyboard/Storag
Legacy (DOS) USB Mouse
Legacy USB storage detect
: Move Enter: Select
F5: Previous Values
To set up a RAID array, ensure that NV SATA RAID function, SATA Primary Master RAID and SATA
Secndry Master RAID are Enabled (Figure 2), otherwise set them to Disabled.
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
NV SATA RAID function
SATA Primary Master RAID
SATA Secndry Master RAID
: Move Enter: Select
F5: Previous Values
The BIOS Setup menus described in this section may not show the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
GA-MF3 Motherboard
Integrated Peripherals
[Press Enter]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[SHADOW]
[Auto]
[Auto]
[Disabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
3
[V1.1+V2.0]
[Disabled]
[Disabled]
[Enabled]
+/-/PU/PD: Value F10: Save
¹Ï1
F7: Optimized Defaults
Figure 1
RAID Config
[Enabled]
[Enabled]
[Enabled]
+/-/PU/PD: Value F10: Save
F7: Optimized Defaults
Figure 2
- 64 -
Item Help
Menu Level
ESC: Exit F1: General Help
Item Help
Menu Level
ESC: Exit F1: General Help