Gigabyte GA-G1975X-C User Manual page 79

(3) Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to Section 4 if
you do not want to create RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message
which says "Press <Ctrl-I> to enter Configuration utility" (Figure 4). Press CTRL+ I to enter the RAID
BIOS setup utility.
Intel(R) Matrix Storage Manager option ROM V5.0.0.1032 ICH7R wRAID5
Copyright(C) 2003-05 Intel Corporation. All Rights Reversed.
RAID Volumes :
None Defined.
Physical Disks :
Port Driver Model
0 ST3120026AS
1 ST3120026AS
Press <CTRL - I>
Step 2:
After you press CTRL+ I, the Create RAID Volume screen will appear (Figure 5).
Create RAID Volume¡G
If you want to create RAID array, select Create RAID Volume in Main Menu and press ENTER.
Intel(R) Matrix Storage Manager option ROM V5.0.0.1032 ICH7R wRAID5
RAID Volumes :
None Defined.
Physical Disks :
Port Driver Model
0 ST3120026AS
1 ST3120026AS
[ ]-Select
Serial #
3JT354CP
3JT329JX
to enter Configuration Utility
Figure 4
Copyright(C) 2003-05 Intel Corporation. All Rights Reversed.
[ MAIN MENU ]
1.Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
4. Exit
[ DISK/VOLUME INFORMATION ]
Serial #
3JT354CP
3JT329JX
[ESC]-Exit
Figure 5
- 79 -
Size Type/Status(Vol ID)
111.7GB Non-RAID Disk
111.7GB Non-RAID Disk
Size Type/Status(Vol ID)
111.7GB Non-RAID Disk
111.7GB Non-RAID Disk
[ENTER]-Select Menu
Appendix