Auto Colour Calibration - Ricoh DSc332 Operating Instructions Manual

Auto Colour Calibration

If a certain colour is strong or the col-
our of the copy differs from the origi-
nal, adjust the yellow, magenta, cyan
and black balance.
Note
❒ If "DToner is almost empty." is
shown on the display panel, the
test pattern cannot be printed.
A A A A
Press the { { { { User Tools/Counter} } } } key.
B B B B
Press [Maintenance].
C C C C
Press [Auto Colour Calibration].
D D D D
Press [Start] on the "Copier Func-
tion".
Note
❒ When performing the auto col-
our calibration from the copy
function, press [Start] under
Copier Function. When per-
forming from the printer func-
tion, press [Start] under Printer
Function.
E E E E
Press [Start Printing] and a test pat-
tern will be printed.
Note
❒ When performing the auto col-
our calibration from the printer
function, select test patterns
from [600 x 600 dpi], [1800× × × × 600
dpi] and [1200 x 1200 dpi] and
then press [Start Printing]
❒ The test pattern will be printed
on an A4K, 8
page (If A4K is not available
then A3 L, B4 JISL will be
used.). Make sure to check the
paper set in the paper tray.
❒ The counter will not proceed
when the test pattern is printed.
ZFLS110E
F F F F
Place the test pattern on the expo-
sure glass and press [Start Scan-
ning].
The image will be corrected after
"
Please wait.
Note
❒ The test pattern will not be read
if it is set in the ADF.
❒ Set the test pattern in the follow-
ing way:
Adjusting the Colour Registration
1
/ "× 11"K size
2
" disappears.
5
135