Fujitsu FI-4860C Operator's Manual page 228

3) At <Screen 4-1> you can enable or disable the Double-feed detection or
configure the detection modes by pressing
arrow button).
By pressing
By pressing
(1) [Off] is blinking:
(2) [On] and [1] are blinking:
(3) [On] and [2: Full] are blinking: Document overlapping is checked for
4) At <Screen 4-2> you can set the detection range for Double-feed by checking
document overlapping. Press
to set the start and end positions for the detection.
(1) [Top] is blinking:
(2) [L] is blinking:
Press (Next button) or
the selected item. To enable the settings, press
7-22 7.3 Setup Mode Details
<Screen4-1>
! 0 4 -
= O f f
(Right arrow button), the selection moves from (1) to (3).
(Left arrow button), the selection moves from (3) to (1).
(Left arrow button) or
<Screen 4-2>
-
! 0 4
T o p :
(Previous button) to increase/decrease the value of
(Right arrow button) or
1 U l t r a
/ O n -> 1 / 2
Document overlapping is not checked.
Document overlapping is checked for
the range set at step 4). This mode is
used for preventing mis-detection when
scanning documents that are pasted
photos, etc.
the whole area of the
documents.(Default setting)
(Right arrow button)
2 S
S U r
0 L
: 1
The start position for the detection is set.
The detection is range set.
(Enter button).
(Left
s o n i c
: F u l l
g e
a n
0 m
0 m