Fujitsu FI-4860C Operator's Manual page 221

LCD Descriptions
display
Baud Rate Specifies the control data
transfer rate for TPS interface.
Imprinter When both fi-486PRFR (Front
side/Pre-print) and fi-
486PRRE (Rear side/Post-
print) are installed, specifies
which one to setup.
Numbering When either fi-486PRFR
(Front side/Pre-print) and fi-
486PRRE (Rear side/Post-
print) is installed, set the
numbering parameters.
Ink Shows the remaining ink.
Reset remaining ink amount
counter when the Print
cartridge is replaced.
Selectable Default
parameters
19200 / 9600
9600 /
4800 /
2400
Pre / Post -
Numbering Numberin
g
: On / Off
: Off
Digits Digits
: 5 / 8 : 5
Initial No.: Initial No.:
5digit:0-99999 00000
8digit:
0-16777215
Reset at hopper Reset at
empty: On/Off hopper
empty: On
- -
7.2 Setup mode functions
Mode Remarks
On- Off-
line line
Not Avail- New setting
Avail- able valid after
able power cycle.
Avail- Avail- -
able able
Avail- Avail- Settings via the
able able PC have the
priority.
Avail- Avail- -
able able
7
7-15