Fujitsu FI-4860C Operator's Manual page 227

4. Setting Double-feed detection (document overlapping/thickness)
1) Press (Next button) or
<Screen4>.
2) At <Screen4>, by pressing
Double-feed detection by document thickness can be enabled or disabled. (A
Double-feed is checked by the difference in the amount of ultrasonic waves
and/or the light penetrating through the paper.) In this screen, you can enable or
disable the Double-feed detection and set the detection mode and select error
processing.
By pressing (Right arrow button), the selection moves from (1) to (3).
By pressing (Left arrow button), the selection moves from (3) to (1).
(1) [No] is blinking:
(2) [Yes] and [1] are blinking:
(3) [Yes] and [2: Stop] are blinking: Document overlapping and thickness
To disable the Double-feed detection, select [No] and press
The blinking item is the one selected.
HINT
(Previous button) and let the scanner show
<Screen4>
! 0 4 D o
= N o / Y e
(Left arrow button) or
Document overlapping and thickness
are not checked.
Document overlapping and thickness
are checked.
However, the scanning continues even if
Double-feed is detected and an error
message is displayed on the LCD.
are checked.
When a double-feed is detected, the
scanning stops. Then the error is
reported to the PC.
u b l e F e
S
s 1 / 2 :
(Right arrow button),
(Enter button).
7.3 Setup Mode Details
e d
t o
p
7
7-21