Default Ospf Configuration - Cisco WS-C3750-48PS-S Software Configuration Manual

Configuring OSPF
This section briefly describes how to configure OSPF. It includes this information:
•
•
•
•
•
•
•
•
Note To enable OSPF, the stack master must be running the EMI.

Default OSPF Configuration

Table 34-5
Table 34-5 Default OSPF Configuration
Feature
Interface parameters
Area
Auto cost
Default-information originate
Default metric
Catalyst 3750 Switch Software Configuration Guide
34-26
Default OSPF Configuration, page 34-26
Configuring Basic OSPF Parameters, page 34-27
Configuring OSPF Interfaces, page 34-28
Configuring OSPF Area Parameters, page 34-29
Configuring Other OSPF Parameters, page 34-30
Changing LSA Group Pacing, page 34-32
Configuring a Loopback Interface, page 34-32
Monitoring OSPF, page 34-33
shows the default OSPF configuration.
Default Setting
Cost: No default cost predefined.
Retransmit interval: 5 seconds.
Transmit delay: 1 second.
Priority: 1.
Hello interval: 10 seconds.
Dead interval: 4 times the hello interval.
No authentication.
No password specified.
MD5 authentication disabled.
Authentication type: 0 (no authentication).
Default cost: 1.
Range: Disabled.
Stub: No stub area defined.
NSSA: No NSSA area defined.
100 Mbps.
Disabled. When enabled, the default metric setting is 10, and the
external route type default is Type 2.
Built-in, automatic metric translation, as appropriate for each
routing protocol.
Chapter 34 Configuring IP Unicast Routing
78-16180-02