Using Express Setup - Cisco WS-CBS3120X-S Hardware Installation Manual

Chapter 2 Switch Installation

Using Express Setup

Before you complete the setup program, obtain the default gateway IP address and the switch password
from your system administrator. You can use Express Setup to configure these optional parameters
through the Express Setup program:
•
•
•
•
Follow these steps to finish setting up the switch module. The Onboard Administrator assigns an
IP address and a subnet mask to the management interface (VLAN ID) and to the Ethernet
management port.
Enter this information in the Network Settings fields.
Step 1
•
•
You can enter the Optional Settings information now or enter it later by using the device manager
interface. Some of these settings are on the Advanced Settings tab (see
Figure 2-7
In the Host Name field, enter a name for the switch module. The host name is limited to 31 characters;
Step 2
embedded spaces are not allowed.
In the System Date and System Time fields, enter the current date and time, or use the down arrows to
Step 3
select them.
In the Time Zone field, use the down arrow to choose your time zone.
Step 4
OL-12246-01
Using the Onboard Administrator to Assign an IP Address to the Switch Module and Running Express Setup
Telnet access password
Names of the SNMP read and write community strings if you are going to use a
network-management program like CiscoWorks.
Host name, system contact, and system location
System time, time zone, Daylight Savings Time enable
In the Default Gateway field, enter the IP address for the default gateway (router).
In the Switch Password field, enter your password. The password can be from 1 to 25 alphanumeric
characters, can start with a number, is case sensitive, allows embedded spaces, but does not allow
spaces at the beginning or end.
In the Confirm Switch Password field, enter your password again.
Express Setup Advanced Settings Table
Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide
Figure 2-7).
2-11