Table of Contents
Advertisement
Product Overview
LEDs
LEDs
You can use the LEDs to monitor the switch status, activity, and performance.
the front panel LEDs.
Figure 3
LEDs on the Cisco IE 1000 Switch (PoE Models Only)
DC A
DC B (PoE Only)
SYS
EXP
Express Setup LED
The Express Setup LED displays the express setup mode for the initial configuration.
Color
Off (dark)
Solid green
Blinking green
Solid red
System LED
The System LED shows whether the system is receiving power and is functioning properly.
Color
Off
Green
Red
Power connector DC-A LED
Power connector DC-B LED
System LED
Express Setup LED
Setup Status
Switch is configured as a managed switch.
Switch is operating normally.
Switch is in initial setup, in recovery, or initial setup is incomplete.
Switch failed to start initial setup or recovery because there is no available switch port to
which to connect the management station. Disconnect a device from a switch port, and then
press the Express Setup button. The EXP LED will go RED when User attempts to enter
Express Setup mode, but the switch has a startup-configuration already. Express Setup
mode only works when the switch does NOT have a startup-configuration.
System Status
System is not powered on.
System is operating normally.
The switch failed ACT 2 verification. The configuration running on the switch is not
compatible with the running software. Switch is not functioning properly.
Figure 3 on page 6
ALM-OUT (PoE Only)
Alarm Out LED
POE (PoE Only)
POE port status LED
5 (PoE Only)
SFP module slot LED
6 (PoE Only)
SFP module slot LED
6
and
on page 8
show
Advertisement
Table of Contents
