Configuring Ip Multicast Routing; Default Multicast Routing Configuration; Multicast Routing Configuration Guidelines; Pimv1 And Pimv2 Interoperability - Cisco WS-C3560-48PS-S Software Configuration Manual

Configuring IP Multicast Routing

Configuring IP Multicast Routing
These sections describe how to configure IP multicast routing:
•
•
•
•
•
•
•

Default Multicast Routing Configuration

Table 32-2
Table 32-2 Default Multicast Routing Configuration
Feature
Multicast routing
PIM version
PIM mode
PIM RP address
PIM domain border
PIM multicast boundary
Candidate BSRs
Candidate RPs
Shortest-path tree threshold rate
PIM router query message interval

Multicast Routing Configuration Guidelines

To avoid misconfiguring multicast routing on your switch, review the information in these sections:
•
•

PIMv1 and PIMv2 Interoperability

The Cisco PIMv2 implementation provides interoperability and transition between Version 1 and
Version 2, although there might be some minor problems.
Catalyst 3560 Switch Software Configuration Guide
32-8
Default Multicast Routing Configuration, page 32-8
Multicast Routing Configuration Guidelines, page 32-8
Configuring Basic Multicast Routing, page 32-10
Configuring a Rendezvous Point, page 32-11
you want to treat the group as a sparse group)
Using Auto-RP and a BSR, page 32-21
Cisco PIM v1 devices))
Monitoring the RP Mapping Information, page 32-22
Troubleshooting PIMv1 and PIMv2 Interoperability Problems, page 32-22
shows the default multicast routing configuration.
PIMv1 and PIMv2 Interoperability, page 32-8
Auto-RP and BSR Configuration Guidelines, page 32-9
Chapter 32
(required)
(required if the interface is in sparse-dense mode, and
(required for non-Cisco PIMv2 devices to interoperate with
(optional)
Default Setting
Disabled on all interfaces.
Version 2.
No mode is defined.
None configured.
Disabled.
None.
Disabled.
Disabled.
0 kbps.
30 seconds.
Configuring IP Multicast Routing
(optional)
78-16156-01