Configuring Basic Ospf Parameters - Cisco WS-C3560-48PS-S Software Configuration Manual

Configuring OSPF
Table 30-6 Default OSPF Configuration (continued)
Feature
Default metric
Distance OSPF
OSPF database filter
IP OSPF name lookup
Log adjacency changes
Neighbor
Neighbor database filter
Network area
Router ID
Summary address
Timers LSA group pacing
Timers shortest path first (spf)
Virtual link

Configuring Basic OSPF Parameters

Enabling OSPF requires that you create an OSPF routing process, specify the range of IP addresses to
be associated with the routing process, and assign area IDs to be associated with that range.
Beginning in privileged EXEC mode, follow these steps to enable OSPF:
Command
Step 1
configure terminal
Step 2
router ospf process-id
Catalyst 3560 Switch Software Configuration Guide
30-30
Default Setting
Built-in, automatic metric translation, as appropriate for each
routing protocol.
dist1 (all routes within an area): 110.
dist2 (all routes from one area to another): 110.
and dist3 (routes from other routing domains): 110.
Disabled. All outgoing link-state advertisements (LSAs) are
flooded to the interface.
Disabled.
Enabled.
None specified.
Disabled. All outgoing LSAs are flooded to the neighbor.
Disabled.
No OSPF routing process defined.
Disabled.
240 seconds.
spf delay: 5 seconds.
spf-holdtime: 10 seconds.
No area ID or router ID defined.
Hello interval: 10 seconds.
Retransmit interval: 5 seconds.
Transmit delay: 1 second.
Dead interval: 40 seconds.
Authentication key: no key predefined.
Message-digest key (MD5): no key predefined.
Purpose
Enter global configuration mode.
Enable OSPF routing, and enter router configuration mode. The
process ID is an internally used identification parameter that is
locally assigned and can be any positive integer. Each OSPF
routing process has a unique value.
Chapter 30 Configuring IP Unicast Routing
78-16156-01